BK Radio DPH Spécifications télécharger pdf

BK RADIO Page 2-1

INSTALLATION AND PROGRAMMING

2.1 GENERAL INFORMATION

This section contains information concerning the installation and programming of BK Radio DPH

Flex•Mode Series handheld VHF radios.

2.1.1 UNPACKING AND INSPECTING EQUIPMENT

Exercise extreme care when unpacking the equipment. Make a visual inspection of the unit for evidence

of damage incurred during shipment. If a claim for damage is to be made, save the shipping container to

substantiate the claim. The claim should be promptly filed with the transportation company. It would be

advisable to retain the container and packaging material after all equipment has been removed in the

event that equipment storage or reshipment should become necessary.

2.1.2 BATTERY INSTALLATION

A. BK Radio battery packs are available in a variety of sizes and types for special applications.

Rechargeable battery packs can be charged separately or while attached to a radio.

NOTE: For safety reasons, rechargeable battery packs are shipped uncharged or only partially

charged. Therefore, a rechargeable battery pack should be properly charged before use.

B. To install the battery, locate the center hub on the radio base and place it in the recess of the battery

pack. Position the pack approximately at a 30° offset, seating two metal studs in their recess. Apply

upward pressure to the pack while twisting the pack to its final (in line with the radio) position. The

metal tab will click, locking the pack in position.

C. To remove the battery pack, first turn the radio off. Then, as shown above, push up the metal tab on

the side of the case while twisting the battery pack approximately 30° and remove it from the radio.

NOTE: All information programmed into the radio is maintained even when the battery pack is

removed.

D. Periodically check the contacts on the battery pack for dirt that may prevent a good electrical contact

with the charging base.

WARNING: EXPLOSION HAZARD

Do not dispose of a battery pack in fire.

An explosion may occur.

2.1.3 ANTENNA INSTALLATION

Insert the flexible helical-wound antenna into the radio's antenna connector and turn it clockwise until it is

firmly seated.

1 2 3 4 5 6 ... 15 16

Résumé du contenu

Page 1

BK RADIO Page 2-1 INSTALLATION AND PROGRAMMING 2.1 GENERAL INFORMATION This section contains information concerning the installation and programmin

Page 2 - 2.2 KEYBOARD PROGRAMMING

Installation and Programming DPH Series VHF Radio Page 2-10 BK RADIO 2.2.2.10.2 Group Label After the backlight duration setting, the display will

Page 3

DPH Series VHF Radio Installation and Programming BK RADIO Page 2-11 2.2.3 ENTER CHANNEL BANDWIDTH, FREQUENCIES, CHANNEL GUARDS, AND TALK GROUP ID

Page 4

Installation and Programming DPH Series VHF Radio Page 2-12 BK RADIO 9. If the receive mode selected was Digital or Mixed mode, the next field is

Page 5

DPH Series VHF Radio Installation and Programming BK RADIO Page 2-13 17. If the transmit mode selected was Digital or Mixed mode, the next field is

Page 6

Installation and Programming DPH Series VHF Radio Page 2-14 BK RADIO 2.3 CLONING RADIO SETTINGS A D Series portable radio with a keypad and displa

Page 7

DPH Series VHF Radio Installation and Programming BK RADIO Page 2-15 2.3.1 SPECIAL CLONING INSTRUCTIONS It is possible to change Channel 0 values o

Page 8

Installation and Programming DPH Series VHF Radio Page 2-16 BK RADIO 2.5 TONE CODE GUARD VALUES The tone Code Guard system may be set for any freq

Page 9

Installation and Programming DPH Series VHF Radio Page 2-2 BK RADIO 2.2 KEYBOARD PROGRAMMING You can program DPH radios in three different ways: A.

Page 10

DPH Series VHF Radio Installation and Programming BK RADIO Page 2-3 2.2.2 GENERAL PERFORMANCE VARIABLES (CHANNEL 0) Channel 0 settings for each gr

Page 11

Installation and Programming DPH Series VHF Radio Page 2-4 BK RADIO 2.2.2.1 Group Password 1. After entering programming mode the display will s

Page 12

DPH Series VHF Radio Installation and Programming BK RADIO Page 2-5 2.2.2.4 Scan Delay Time After the Time Out Timer is set, the upper display wi

Page 13

Installation and Programming DPH Series VHF Radio Page 2-6 BK RADIO 2.2.2.6.1 Old-Style BK Priority Scan The radio can be programmed to mimic t

Page 14 - 2.3 CLONING RADIO SETTINGS

DPH Series VHF Radio Installation and Programming BK RADIO Page 2-7 2.2.2.7.5 Scan List Lockout When function 5 is enabled (flashing), the user w

Page 15 - 2.4 PROGRAMMING BY COMPUTER

Installation and Programming DPH Series VHF Radio Page 2-8 BK RADIO To set Busy Channel operation use the following chart: FUNCTION 2 FUNCTION 3

Page 16 - 2.5 TONE CODE GUARD VALUES

DPH Series VHF Radio Installation and Programming BK RADIO Page 2-9 2.2.2.9.2 Backlight on Key Press When function 4 is enabled (flashing), the di

Plus de documents pour Radios BK Radio DPH

Voir le document BK Radio DPH Manuel du propriétaire

BK Radio DPH Manuel du propriétaire (21 pages)

BK Radio DPH Manuel du propriétaire (23 pages)

Voir le document BK Radio DPH Manuel d'utilisateur

BK Radio DPH Manuel d'utilisateur (1 pages)

Commentaires sur ces manuels

Pas de commentaire

BK Radio DPH Spécifications

Naviguer en ligne ou télécharger Spécifications pour Radios BK Radio DPH. BK Radio DPH Specifications Manuel d'utilisatio

Résumé du contenu

Plus de documents pour Radios BK Radio DPH

Commentaires sur ces manuels

Produits connexes et manuels pour Radios BK Radio DPH